StoneCARE SHINER

A solvent based, partially penetrating protector and shiner for all kinds of natural stones. StoneCARE SHINER penetrates into the pores of the stone, solidifies in the pores and on the surface as a tough water repellent coating. It forms an invisible barrier for water and various stains and provides a shiny surface.

Application :

·  Test a small area initially.

·  Whole surface to be treated must be wetted with StoneCARE SHINER Evenly use soft brush or paint pad and rub the chemical into the surface and leave to dry and cure for 24 hours.

·  New installed areas must be left for at least 8 hours before the treatment.

·  A second coating can be applied after drying out of first treatment. Highly porous stones may require additional coatings.

·  A bottle of StoneCARE SHINER (0,95 Kg) is sufficient for the treatment of 13-40 m² surface depending on the porosity of the surface.

·  The temperature must not be higher than 25 ^oC during the application, otherwise fast drying and improper penetration will result.

·  Application surface must be free of dust,  and dry/clean.

·  StoneCARE SHINER does not protect acid labile stones (such as marble) against strong acids.

Chemical Properties :
Appearance : A clear solution .

Packing :
1 Quart (860 Gr) bottles - 20 bottles in a cardboard box.
30 Kg polyethylene drums.

Handling and Storage :
Shelf life is at least 1 year if stored at temperatures between 5 - 30 ^oC. This material containes harmful solvents. Do not breath  the vapor. Use only in well ventilated areas. Use a protective mask. Use  gloves and eye protection. It may cause slight burns on the skin, if contacted.

Health Concerns :

·  Keep away from children and animals.

·  This material contains volatile chlorinated hydrocarbons. Use only in well ventilated areas.  Do not smoke.

·  If contacts with skin, dry with a tissue paper and apply soothing cream if necessary.